Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Fontana, CA
Chimney repair in Fontana usually means one of three things: a rusted damper assembly in an original prefab firebox, a cracked clay-tile flue liner from decades of thermal cycling, or a failed chase cap letting Santa Ana wind push dust and debris down the flue. Most homes we see here were built between the 1950s and 1980s, and a lot of those fireplaces were decorative from day one. That means problems sat unnoticed until a home inspection flagged them or a homeowner lit the first fire in years and smelled smoke backing into the living room. We’ve been fixing those exact issues in Fontana since 2014, and we’ll tell you what we found, show you the evidence, and give you options before any work begins. Call (833) 467-7685 for a free estimate.
Why Fontana Homes Are Different
Fontana’s chimney stock tracks the city’s housing boom. The older south-side neighborhoods in 92335 and 92337 are full of single-story stucco tract homes built for Kaiser steel-mill workers, most with original prefab metal fireboxes and clay-tile flues from the 1960s and 1970s. Those units were installed to code at the time, but the code has changed, and so have the components. We regularly find fireboxes with clearances that wouldn’t pass a modern inspection and damper assemblies that rusted out years ago without anyone noticing because the fireplace got used maybe five times a season.
The climate adds its own layer. Fontana’s hot, dry summers pull moisture out of mortar and crown material, and the Santa Ana episodes in fall push fine desert dust into any uncapped flue. Then winter comes, and a homeowner burns a few fires over the mild season, producing soft, glazed creosote that looks different from the hard, flaky stuff you’d get from heavy use. A technician who treats that glazed creosote like routine soot is going to miss what it’s doing to the liner. The newer north-side development in 92336 has more two-story homes with modern factory-built inserts, and those bring their own quirks: shorter vent runs, tighter clearances, and more vent pipe exposed to wind-driven rain. Knowing which era of Fontana housing you’re in changes what we look for on a repair job.
Styles & brands we work with
Our Main Fontana Services
Most Fontana homeowners call us for one of two things: a chimney sweep before burning season or a dryer vent cleaning after noticing laundry taking two cycles to dry. Both are maintenance jobs that prevent bigger problems, and both are handled by the same trained technicians.
Chimney Sweep in Fontana
A sweep in Fontana is less about heavy creosote buildup and more about confirming the system is safe before you light that first fire of the year. We remove the accumulated soot and the soft, glazed creosote that forms from intermittent winter burning, then we inspect the flue, the damper, and the cap while we’re up there. The dust intrusion from Santa Ana winds means caps and dampers get checked closely on every visit, because a failed damper in an older south Fontana home is a common find even when the flue itself is clean. If you’re in 92335 or 92337 and you haven’t had the chimney looked at in years, start with a sweep and let us document what we see. Learn more about Chimney Sweep in Fontana.
Dryer Vent Cleaning in Fontana
Dryer vent cleaning gets called a fire-safety service for good reason. The NFPA attributes thousands of home fires a year to dryer vents, and lint buildup is a mechanical certainty in any vent that runs more than a few feet. Fontana’s dry air and the fine dust that settles everywhere make dryer vents here collect lint a little faster than you’d expect, especially in older homes where the vent run is long or the termination is in a hard-to-reach spot. We clean the full run and verify airflow at the termination, not just the first few feet behind the dryer. It’s a standalone service with us, not an add-on. See Dryer Vent Cleaning in Fontana for the full scope.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Fontana
Most chimney repair work in Fontana traces back to the housing era and the weather. A 1968 prefab firebox in a south-side tract home has been sitting in dry heat for over fifty years, and the metal components don’t age gracefully in that climate. Dampers rust, firebox panels crack, and clay-tile liners spall from years of thermal expansion and contraction. Then a Santa Ana wind episode pushes debris down the uncapped flue, and suddenly the homeowner has a smoke smell they can’t place. We handle the full repair scope, from Chimney Repair inspection through completion, so you’re not coordinating between a sweep who cleans and a contractor who rebuilds. One company from inspection to repair.
Chimney Cap Installation
Signs you need it
You see rust staining on the chase cover, hear wind noise inside the firebox, or find bird nesting material at the base of the flue.
What it costs in Fontana
A chimney cap installation in Fontana typically runs $200 – $450 depending on the flue size and whether we need to fabricate a custom mounting bracket for an older prefab unit.
How we do it
We measure the flue, select a stainless cap from Famco or a matching brand, mount it to the crown or chase with mechanical fasteners, and verify draw with a smoke test.
Chimney Crown Repair
Signs you need it
The mortar crown has visible cracks or spalling, or water is staining the ceiling near the fireplace after rain.
What it costs in Fontana
Chimney crown repair in Fontana ranges from $400 – $900 for a resurfaced crown, and a full replacement can run $900 – $2,500 when the original crown is beyond saving.
How we do it
We clean the existing crown surface, repair or remove the damaged material, apply a new crown with proper slope and overhang, and seal the joint where the flue meets the crown.
Chimney Liner Installation
Signs you need it
You see clay tile fragments in the firebox, a camera inspection shows cracks or gaps in the flue, or the original liner is uninsulated and spalling.
What it costs in Fontana
A chimney liner installation in Fontana typically runs $2,500 – $5,000 for a stainless steel system, with the higher end covering taller flues or offset chimney routing.
How we do it
We run a camera to confirm flue condition, size the liner to the appliance and flue dimensions, install a DuraFlex stainless liner from top to bottom, insulate where required, and terminate with a proper cap.
What Chimney Repair Costs in Fontana
| Item | Typical range in Fontana |
|---|---|
| Chimney cap installation | $200 – $450 |
| Chimney crown repair | $400 – $900 |
| Chimney liner installation | $2,500 – $5,000 |
These are the ranges we quote most often in Fontana. The two things that push a job toward the higher end are flue access and the condition of what we find once we’re inside. An older prefab unit with a rusted chase top and a spalled clay liner is a bigger job than a clean swap on a newer home. We give you a flat price before work begins, so the number you agree to is the number you pay.
Do Fontana homes need their original clay liners replaced?
Not always. Many original clay-tile liners in 1960s and 1970s Fontana homes are still intact, especially if the fireplace saw light use. But if a camera inspection shows spalling, cracking, or gaps between tiles, replacing or resurfacing is the correct fix. We show you the footage so you can see exactly what we’re seeing before you spend anything.
How long does chimney repair take in Fontana?
Most cap and crown jobs finish in a single visit, usually two to four hours. Liner installations take a half day to a full day depending on flue height and access. We schedule around Fontana’s mild winter burning season, which means repairs requested in September and October fill up faster than spring work. Call (833) 467-7685 to get on the schedule.
Brands We Service in Fontana
We stock and install parts from Copperfield, Famco, and DuraFlex because those are the materials certified chimney professionals actually specify. When a Fontana job needs a stainless liner or a replacement damper, we’re not pulling a universal part off a hardware-store shelf. See our brands for the full list and what each one is used for.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Fontana, CA
| Service | Typical range in Fontana |
|---|---|
| Chimney sweep | $179 – $290 |
| Dryer vent cleaning | $99 – $250 |
| Chimney cap installation | $200 – $450 |
| Chimney cap replacement | $250 – $450 |
| Chimney crown repair | $400 – $900 |
| Chimney crown replacement | $900 – $2,500 |
| Chimney flashing repair | $300 – $800 |
| Chimney liner installation | $2,500 – $5,000 |
| Chimney liner resurfacing (HeatShield) | $2,000 – $4,000 |
In Fontana, two things push pricing up more than anything else: the age of the housing stock and what’s happened to the top of the chimney. Original prefab units from the 1960s and 1970s often need custom cap work or liner sizing that a newer factory-built insert would not, and years of Santa Ana-driven debris can chew up a chase cover in ways that compound a simple cap replacement. We quote a flat price on every job and send you photos or camera footage before any work is approved, so the quote on paper matches what we actually do.
Neighborhoods We Serve in Fontana
We work across Fontana’s full span, from the older tracts south of Foothill Boulevard through the newer subdivisions north of the 210 and out to the far-west edge near Glen Avon. Our techs have been through the original concrete-slab neighborhoods around Citrus and Jurupa and the two-story developments that came later. Most Fontana calls get a calendar opening within the week.
- Southridge
- Citrus Heights
- Downtown Fontana
- Lytle Creek North
- West End
Service Area – Cities Near Fontana
Our service area runs from Fontana proper into the surrounding Inland Empire communities. We handle chimney and venting work in Bloomington, CA, Rialto, CA, Glen Avon, CA, and Pedley, CA. If you’re in any of these cities, the same pricing, the same brands, and the same flat-price promise apply. Call (833) 467-7685 and tell us what city you’re in.
Serving Fontana, CA — Our Local Coverage Area
We’re based in the Fontana area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Fontana
Most Fontana homeowners get an appointment within five to seven business days. During September and October, before burning season, we add scheduling blocks for Fontana because that’s when most sweep requests come in. If you have a repair need after an inspection flagged something, call (833) 467-7685 and we’ll fit you in based on urgency.
Basic repairs like cap installation, crown resurfacing, and sweeps do not require a permit in Fontana. Liner installations do not typically require a permit when we’re working within the existing flue structure. We’ll tell you before we start if your specific project crosses a threshold that requires city involvement.
Move anything flammable away from the fireplace and keep pets in another room if possible. If we’re doing a roof-level job, clear any vehicles from the driveway area we might need to access with a ladder. We bring all equipment and drop cloths, and the work area is clean when we leave.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Fontana Customers Say
"Drop cloths everywhere, HEPA vac, and not a speck of soot on the carpet. I'd been dreading the mess for nothing."
— Bethany Padgett"Level two inspection before we bought the house. The report was detailed enough to use as a negotiating point and he explained every photo in it."
— Sarah Sullivan"Good work. The written inspection report took about a week to arrive after I asked for it, which was slower than I expected."
— Adriana Morales