Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Norco, CA
Most chimney repair calls we take in Norco come from ranch homes built between the 1950s and 1980s, where masonry fireplaces and freestanding wood stoves have been working hard for decades. Homeowners here burn more wood, more often, than almost anywhere else in Riverside County. That means we see creosote-glazed flues, cracked crowns, rusted-out caps, and failed flashing on a regular basis. If you’re looking for a chimney company in Norco that understands how these older, heavy-use systems fail, you’ve found us. Call (833) 467-7685 and we’ll schedule an inspection.
Why Norco Homes Are Different
Norco isn’t a typical Riverside County subdivision. The city is built around horse property: half-acre lots, ranches, barns, and detached outbuildings that have been here since the middle of the last century. Most of the chimneys we work on in Norco are attached to wood-burning fireplaces or freestanding wood stoves that get lit almost every winter evening, then sit dormant through the long hot summers. That cycle matters. Chimneys that sit idle for months collect dust, nesting material, and the dry conditions that make creosote dangerously brittle and flaky when burn season finally arrives.
The firewood situation in Norco is unusual too. Homeowners out here burn a lot of locally cut eucalyptus, citrus, and avocado wood. Those are dense, resinous species that season slowly and produce thick, sticky smoke. The creosote they leave behind is different from what you’d find in a Corona tract home burning kiln-dried pine. In Norco, we regularly see glazed, tar-like creosote coatings that a standard brush sweep won’t fully remove without chemical treatment and follow-up work. That’s the kind of thing you need to know before you light the first fire of the season.
We also work on flues and stovepipe runs in detached barns, shops, and garage conversions. Some of those secondary chimneys haven’t been inspected in decades, and they’re often the ones with the worst corrosion, animal intrusion, and structural settling.
Styles & brands we work with
Our Main Norco Services
The two services Norco homeowners call about more than anything else are chimney sweeping and dryer vent cleaning. Here’s how each one works in this area.
Chimney Sweep in Norco
A chimney sweep in Norco means more than a quick brush up the flue. With the amount of eucalyptus and citrus wood burned out here, we’re usually dealing with heavy creosote buildup, sometimes glazed and hardened. We remove the deposits, inspect the flue liner and smoke chamber for cracks or gaps, check the cap and crown, and tell you exactly what we found. If your home has a freestanding wood stove, we sweep that connector pipe and stovepipe run too. For a detailed look at what’s included, see our Chimney Sweep in Norco page.
Dryer Vent Cleaning in Norco
Dryer vent fires are one of the most preventable causes of house fires in the country, and Norco’s long dry season doesn’t help. Lint, dust, and the occasional bird nest accumulate in dryer exhaust runs, especially in older ranch homes where the vent pipe may run a long distance from the laundry room to an exterior wall. We clean the full run, check the termination hood, and make sure the vent is drafting the way it should. Norco’s dry, gusty Santa Ana season means any restriction in that vent becomes a real fire risk. Learn more on our Dryer Vent Cleaning in Norco page.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Norco
Norco’s older ranch homes have chimneys that have been through decades of heavy wood burning, hot dry summers, and gusty Santa Ana winds. The problems we see most often are cracked chimney crowns, rusted caps, deteriorated flashing, and flue liners that have deteriorated to the point where they’re unsafe to use. If you have a chimney on a Norco property that hasn’t been repaired in 20 or 30 years, the right starting point is Chimney Repair work, beginning with a thorough camera inspection so we know exactly what’s failing.
Chimney Cap Installation
Signs you need it
You currently have no cap on your chimney, or the cap that’s there is rusted through, missing its mesh sides, or letting rain and birds into the flue.
What it costs in Norco
A new chimney cap installed in Norco typically runs $215 to $425 depending on the flue size and the cap material you choose.
How we do it
We measure the flue opening, install a stainless steel cap sized for proper draft, and secure it so Norco’s Santa Ana winds can’t shift it.
Chimney Cap Replacement
Signs you need it
The existing cap is corroded, the mesh is torn (which lets birds and embers through), or the cap was blown loose by wind and is no longer seated correctly.
What it costs in Norco
Replacing a failed chimney cap in Norco generally falls between $215 and $425, including removal of the old cap.
How we do it
We remove the old cap, inspect the flue tile and crown underneath, and install a replacement cap that matches the flue dimensions and handles Norco’s wind exposure.
Chimney Flashing Repair
Signs you need it
You’re seeing water stains on the ceiling or walls near the chimney, or the metal flashing where the chimney meets the roof is lifting, cracked, or missing sections.
What it costs in Norco
Flashing repair in Norco typically ranges from $300 to $650 depending on how much of the existing flashing needs to be replaced.
How we do it
We cut back the old flashing, install new step and counter flashing, and seal the transitions so the chimney won’t leak during Norco’s winter rain events.
Chimney Liner Installation
Signs you need it
A camera inspection shows cracked flue tiles, gaps in the mortar joints, or missing sections of the liner that allow heat and combustion gases to reach the chimney structure.
What it costs in Norco
Liner installation in Norco usually costs between $2,000 and $4,000 depending on the flue size, the liner material, and whether it’s a straight or offset flue.
How we do it
We run a camera inspection first, then use a DuraFlex stainless steel liner system, which handles offset flues that rigid liners can’t navigate.
What Chimney Repair Costs in Norco
| Item | Typical range in Norco |
|---|---|
| Chimney cap installation | $215 – $425 |
| Chimney cap replacement | $215 – $425 |
| Chimney flashing repair | $300 – $650 |
| Chimney liner installation | $2,000 – $4,000 |
How long does a chimney liner last in Norco?
A stainless steel liner on a regularly used Norco fireplace typically lasts 15 to 25 years. Heavy wood burning with resinous wood like eucalyptus shortens that lifespan, so an annual camera check after year 10 is the smart move.
Can I keep using my fireplace while waiting for a repair?
If the flue liner is damaged or the flashing is leaking, no. The risk of chimney fire or structural water damage is too high. We’ll tell you honestly whether you can burn safely, and what has to happen before you should. Call (833) 467-7685 for a straight answer.
Brands We Service in Norco
We install and service DuraFlex stainless steel liners, HeatShield ceramic resurfacing, and caps and dampers from Gelco and Copperfield. These are materials specified by certified chimney professionals, and we keep common replacement parts on hand so Norco repairs don’t drag on waiting for shipments. See our brands for details on what we stock.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Norco, CA
| Service | Typical range in Norco |
|---|---|
| Chimney sweep | $169 – $240 |
| Chimney inspection | $85 – $380 |
| Dryer vent cleaning | $120 – $220 |
| Chimney cap installation | $215 – $425 |
| Chimney cap replacement | $215 – $425 |
| Chimney flashing repair | $300 – $650 |
| Chimney crown repair | $300 – $1,200 |
| Chimney liner installation | $2,000 – $4,000 |
| HeatShield resurfacing | $1,500 – $4,500 |
What pushes prices up in Norco: heavy creosote buildup that requires multiple passes and chemical treatment, chimneys on steep rooflines that need extra ladder and safety setup, and flues that haven’t been inspected in years and turn up structural issues once we’re inside. We price every job before work starts, and we never spring a surprise charge at the end.
Neighborhoods We Serve in Norco
We work across all of Norco’s 92860 ZIP code, from the ranch properties off 6th Street to the older homes near Hamner Avenue and the horse-zoned lots stretching toward the Santa Ana River. No matter which side of town you’re on, we can usually reach you within a day or two, and emergency chimney situations get prioritized.
- Norco Hills
- Norco Ridge
- Wild Rose Ranch
- The Bluffs
- River Trails
Service Area – Cities Near Norco
In addition to Norco, we provide the same chimney repair, sweeping, and dryer vent services to nearby communities. We work regularly in Eastvale, CA, Home Gardens, CA, Corona, CA, and Jurupa Valley, CA. If you’re just over the city line, give us a call and we’ll confirm availability.
Serving Norco, CA — Our Local Coverage Area
We’re based in the Norco area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Norco
Most routine chimney repair, relining, and cap work in Norco doesn’t require a separate permit, but structural rebuilds sometimes do. We’ll tell you before work starts if your project needs city approval, and the scope we’d prepare for the permit package.
For inspections and routine sweeps, we typically schedule within a few business days for Norco addresses. If you have an active leak or a flue that’s been flagged as unsafe, call (833) 467-7685 and we’ll look for the earliest possible slot.
Yes. Norco has a lot of secondary stoves in outbuildings, and those runs are often overlooked for years. We sweep, inspect, and repair stovepipe and flue runs in barns, shops, and garage conversions the same way we do for the main house.
If your chimney needs real attention from a company that knows Norco’s wood-burning habits, call Ontario Chimney at (833) 467-7685. You’ll get a straight answer, a clear price, and work done with materials that last.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Norco Customers Say
"Good work. The written inspection report took about a week to arrive after I asked for it, which was slower than I expected."
— Adriana Morales"Cap keeps the birds out now, which after two springs of scratching noises is worth every penny."
— Tara Novak"Liner was cracked in two places. He walked me through the repair options honestly, including the one that was cheaper for him and better for me."
— Eric Tran