Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Newport Beach, CA
Chimney repair in Newport Beach usually means dealing with what salt air and marine dampness have done to a flue that sits idle ten months a year. We work on 1920s beach cottages on Balboa Island, mid-century ranches in 92660, and large custom homes in Newport Coast, and the problems repeat: rusted dampers, spalled firebrick, corroded caps, and musty odors that come back the moment the fireplace is lit. Ontario Chimney has served Newport Beach since 2014. Call (833) 467-7685 for a straight answer and a free estimate.
Why Newport Beach Homes Are Different
Newport Beach’s coastal air works against a chimney in ways inland heat never does. Morning fog rolls in off the Pacific, salt spray travels on the breeze, and fires here are lit sporadically through the holiday season rather than nightly all winter. That means a chimney in Newport Beach is usually cold and damp. It catches rust on the damper, moisture in the masonry, and nesting material from gulls on the roof instead of building up thick creosote the way a mountain cabin chimney does. On Balboa Island and the Peninsula, technicians routinely meet chimneys that have not been swept in years because the owners light them only during the December boat parade. That same roof often has a salt-corroded cap and a gull nest leaning against the flue. Across 92660 and 92663, the housing stock spans 1920s beach cottages with narrow masonry flues, mid-century and 1960s-70s tract homes, and modern custom builds with prefab or gas-insert systems. Each one ages differently in this air. A narrow 1940s flue on Balboa Island behaves nothing like a 1990s prefab chimney in Newport Coast, and a repair that works on one is wrong for the other. Coastal salt air makes a chimney sweep here as much a moisture-management and odor-control job as a creosote-removal job.
Styles & brands we work with
Our Main Newport Beach Services
Most Newport Beach homeowners call us for one of two reasons: a chimney that has not been touched in years and smells when lit, or a dryer vent that has never been cleaned since the house was built. Both are maintenance issues with real safety stakes.
Chimney Sweep in Newport Beach
A sweep in Newport Beach starts with the assumption that the flue has been sitting cold, damp, and unused for months. We check for creosote, but we are also looking for rust on the damper assembly, spalling brick, moisture staining, and any sign that birds have set up in the flue. Coastal homes here often carry a musty fireplace smell that is not creosote at all; it is damp soot and salt residue. The sweep removes it and identifies why it formed. If you light fires during the December boat parade and holiday season, this is the visit that tells you whether the chimney is safe to use. Chimney Sweep in Newport Beach covers full details, pricing, and what to expect on the day.
Dryer Vent Cleaning in Newport Beach
Dryer vents collect lint. In Newport Beach, the bigger issue is that many homes route the vent through a long interior wall or up through the roof, and those runs are rarely cleaned because they are out of sight. A clogged dryer vent is a documented fire risk – the NFPA points to dryer vent lint as a leading cause of home laundry fires. In beach cottages with tight laundry closets and stacked units, the vent run is often short but kinked. In larger 1960s-70s homes, it is long and neglected. We clean the full run, confirm airflow at the termination point, and tell you what we found. So-called “dryer vent cleaning” services that spend ten minutes vacuuming the lint trap are not doing the same job. Dryer Vent Cleaning in Newport Beach has the full scope and pricing.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Newport Beach
Chimney repair in Newport Beach is driven by two forces: the age of the housing stock and the salt-laden marine air. A 1920s beach cottage on the Peninsula has a different failure profile than a 2000s custom home above the bay, but both deal with corrosion and moisture intrusion. The job usually starts with finding the actual problem, not guessing at it. We put a camera up the flue and show you the footage before recommending anything. Chimney Repair is our full-service line, from a rusted damper to a full reline.
Chimney Cap Installation
Signs you need it
Water pooling in the firebox after rain, rust staining at the top of the flue, a rusted or missing cap, or nesting material falling into the fireplace are all signs the cap is gone or failing.
What it costs in Newport Beach
A standard chimney cap installation in Newport Beach runs $250 to $600, and a custom stainless cap for an unusual flue size runs $450 to $900.
How we do it
We measure the flue opening, fit the correct cap for the chimney type, seal and secure it against salt spray and wind, and confirm the draft is unobstructed.
Chimney Cap Replacement
Signs you need it
A cap with rusted-through mesh, missing side skirts, or one that no longer sits flush on the crown no longer keeps rain, birds, or salt spray out.
What it costs in Newport Beach
Chimney cap replacement in Newport Beach typically costs $250 to $600 for a standard cap and $450 to $900 for a custom-fit stainless cap.
How we do it
We remove the old cap, clean the mounting surface on the crown, fit the new cap to the flue dimensions, and secure it with stainless fasteners suited to coastal air.
Chimney Liner Installation
Signs you need it
Flue tile cracks seen on camera, loose mortar joints in the flue, smoke smell in adjacent rooms, or a liner that has started to flake or collapse means the liner is no longer containing combustion gases.
What it costs in Newport Beach
A standard chimney liner installation in Newport Beach starts around $2,000 and runs to $5,000; custom or multi-story jobs with access challenges run $5,000 to $8,000.
How we do it
We size the flue, install a DuraFlex stainless liner system suited to the existing masonry, insulate where the flue runs near combustibles, and connect it to the appliance collar.
Chimney Flashing Repair
Signs you need it
A water stain on the ceiling near the chimney, damp drywall in the attic around the chase, or visible gaps in the flashing at the roofline mean that water is getting in where the chimney meets the roof.
What it costs in Newport Beach
Chimney flashing repair in Newport Beach typically runs $350 to $700 for a straightforward repair; a full replacement with new step and counter flashing runs $700 to $1,500.
How we do it
We open the shingles or tile around the transition, replace or reseal the step and counter flashing, and test the repair for water intrusion after the job.
Chimney Crown Repair
Signs you need it
A cracked, chipped, or eroded crown surface that holds water, or one that has worn down to the point that the flue tile is exposed, will let water into the masonry below.
What it costs in Newport Beach
Resurfacing a chimney crown in Newport Beach typically costs $400 to $700, and a full crown rebuild runs $1,000 to $2,000 depending on the size and access.
How we do it
We remove the deteriorated crown material, form a proper overhang and drip edge, pour a new crown with a weather-resistant mix, and seal the flue tile and cap together.
What Chimney Repair Costs in Newport Beach
| Item | Typical range in Newport Beach |
|---|---|
| Chimney cap installation | $250 – $600 |
| Custom stainless cap | $450 – $900 |
| Chimney liner installation (standard) | $2,000 – $5,000 |
| Chimney liner installation (custom / multi-story) | $5,000 – $8,000 |
| Chimney flashing repair | $350 – $700 |
| Chimney flashing replacement | $700 – $1,500 |
| Chimney crown repair | $400 – $700 |
| Chimney crown rebuild | $1,000 – $2,000 |
Prices climb in Newport Beach when the job is on a three-story bayfront home with roof access from a ladder, when the flue is an unusual size from a 1920s or 1930s build, or when salt corrosion has damaged the surrounding masonry and the repair scope grows. Every job gets a flat-price quote before work begins, and nothing is recommended without camera evidence you can see.
Do I really need a new liner, or can the old one be patched?
If the liner has a few hairline cracks in otherwise sound tile, a HeatShield ceramic resurfacing can restore it without a tear-out. If the flue tiles have shifted, collapsed, or separated at the joints, patching will not hold and a DuraFlex stainless liner is the correct fix. We show you the camera footage either way so the recommendation is based on evidence, not a sales script. Call (833) 467-7685 for an exact assessment.
How long does chimney repair take in Newport Beach?
Most cap, flashing, and crown repairs are done in one visit. A liner installation takes a full day, sometimes a day and a half on a tall or hard-to-access Newport Beach home. We schedule around coastal weather windows so the repair is not rushed in fog or rain. Call (833) 467-7685 and we’ll give you a realistic timeline after we see the chimney.
Brands We Service in Newport Beach
We install and service DuraFlex stainless liner systems, HeatShield ceramic flue resurfacing, and a curated range of caps and dampers sourced through Copperfield and Olympia Chimney, the two largest professional chimney supply distributors in the trade. Parts are ordered locally and usually arrive within days, not weeks. See our brands for the full list.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Newport Beach, CA
| Service | Typical range in Newport Beach |
|---|---|
| Chimney sweep (standard, single flue) | $180 – $340 |
| Chimney sweep with salt-air inspection and light odor treatment | $300 – $475 |
| Dryer vent cleaning (standard short run) | $120 – $250 |
| Dryer vent cleaning (long or multi-story run) | $250 – $450 |
| Chimney cap installation | $250 – $600 |
| Custom stainless cap | $450 – $900 |
| Chimney liner installation (standard) | $2,000 – $5,000 |
| Chimney liner installation (custom / multi-story) | $5,000 – $8,000 |
| Chimney flashing repair | $350 – $700 |
| Chimney flashing replacement | $700 – $1,500 |
| Chimney crown repair | $400 – $700 |
| Chimney crown rebuild | $1,000 – $2,000 |
What pushes a price up in Newport Beach is almost always access: a three-story bayfront roofline, a 1920s flue with an unusual tile size, or a chimney buried in a tight courtyard. Salt corrosion near the coast also adds scope when the crown and cap need work at the same time. You get a flat quote before we begin, and the price we quote is the price you pay.
Neighborhoods We Serve in Newport Beach
We cover the full city, from the beach cottages and tight lots of the Balboa Peninsula to the larger lots of Newport Coast. Response time across Newport Beach is typically one to two business days for a sweep or inspection, and repair scheduling is set around the tide of coastal weather so jobs are not rushed in fog or rain.
- Balboa Peninsula
- Balboa Island
- Lido Isle
- Newport Heights
- Newport Coast
Service Area – Cities Near Newport Beach
Our route into Newport Beach regularly takes us through the neighboring cities along the 55, 73, and PCH corridors. Homeowners in Costa Mesa, CA and Fountain Valley, CA call us for the same salt-air inspection work, and we serve San Joaquin Hills, CA and Irvine, CA for dryer vent and chimney maintenance as well.
Serving Newport Beach, CA — Our Local Coverage Area
We’re based in the Newport Beach area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Newport Beach
Most Newport Beach appointments are scheduled within one to two business days. During the weeks around Thanksgiving and the December boat parade, demand picks up and scheduling tightens, so call earlier in the fall if you want the fireplace ready for the holidays. Call (833) 467-7685 to reserve a slot.
Routine sweeps, cap replacements, and liner installations inside the existing flue do not usually require permits. Some Newport Beach HOAs, particularly in Newport Coast and gated communities, require prior notice for roof access or exterior changes. We can tell you what is typically needed for your specific community once we know the location.
Yes. We work on Balboa Island, the Balboa Peninsula, and every other Newport Beach neighborhood. The cottages on the island often have narrow masonry flues and roofs with gull activity, and we schedule access around the narrow alleys and tight parking so the truck does not block the street.
If you have a chimney in Newport Beach and want a straight assessment of what it needs, call (833) 467-7685. We will Inspect it, show you what we found, and quote the work before anything is scheduled. The estimate is free.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Newport Beach Customers Say
"Level two inspection before we bought the house. The report was detailed enough to use as a negotiating point and he explained every photo in it."
— Sarah Sullivan"Good work. The written inspection report took about a week to arrive after I asked for it, which was slower than I expected."
— Adriana Morales"Cap keeps the birds out now, which after two springs of scratching noises is worth every penny."
— Tara Novak