Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Murrieta Hot Springs, CA
Most of the chimney work we do in Murrieta Hot Springs is repair, not routine sweeping. Homes here were largely built between the 1980s and early 2000s, and many flues have never had a proper inspection since construction. The hot, dry summers and Santa Ana winds push debris, embers, and birds’ nests into uncapped flues, and a fireplace that gets used only a handful of nights each year still needs a sound flue to vent combustion gases. That’s where we come in. Ontario Chimney handles the full repair scope in Murrieta Hot Springs, from crown and flashing work to liner replacement, so you deal with one company from inspection through completion. Call (833) 467-7685 for a free estimate.
Why Murrieta Hot Springs Homes Are Different
Murrieta Hot Springs sits in a Cal Fire-designated high fire severity zone. That changes what a chimney company actually finds here. Wood-burning fireplaces are common in the 92563 ZIP, but they’re rarely used as a primary heat source. Instead of thick creosote from heavy burning, we find debris, bird nests, and wind-blown ash packed into flues that have been dormant for years. That’s a fire-safety problem as much as a performance problem. Embers from a Santa Ana wind event can enter an uncapped flue and smolder on accumulated leaf litter. A spark-arresting cap is often the single most valuable repair we recommend here, not just for animal exclusion but for defensible-space and fire-safety prep. The tract houses and gated-community builds throughout the area also share a common issue: prefab inserts with aging components and masonry fireplaces with crowns that crack under the repeated dry-heat cycle. Mild winters mean homeowners rarely think about their chimney until something visible fails, which is exactly when the repair bill gets bigger.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Main Murrieta Hot Springs Services
Two services account for most of what Murrieta Hot Springs homeowners call us about: chimney sweeping and dryer vent cleaning. Both are fire-safety maintenance, and both are under-served in this area because fireplaces and dryers run quietly in the background until something goes wrong.
Chimney Sweep in Murrieta Hot Springs
A sweep in Murrieta Hot Springs is less about removing heavy creosote and more about clearing out what the wind and local wildlife leave behind. Birds’ nests, leaf litter, and ash from the rare fire are what we typically pull from flues here. The mild winters mean fireplaces get used a few nights a year, but the Santa Ana winds blow debris onto roofs and into flue caps constantly. We document everything with a camera inspection before and after, so you see exactly what was in your flue. For the full sweep detail, see Chimney Sweep in Murrieta Hot Springs.
Dryer Vent Cleaning in Murrieta Hot Springs
Dryer vent cleaning is a core fire-safety service in Murrieta Hot Springs, not an add-on. Lint builds up in the vent run, restricts airflow, and creates the conditions for a dryer fire. The CPSC and NFPA both identify clothes dryers as a leading cause of residential fires, and most of those fires trace back to uncleaned vents. Homes in this area often have longer vent runs through walls and attics, which means lint accumulates faster. Read the full service breakdown at Dryer Vent Cleaning in Murrieta Hot Springs.
Chimney Repair in Murrieta Hot Springs
Chimney repair in Murrieta Hot Springs usually starts with one visible problem and ends with us finding two or three others once we get on the roof. The 1980s-to-2000s housing stock here means crowns are cracking, flashing is pulling away, and flues that never got a proper inspection are now showing their age. The dry heat and Santa Ana winds accelerate every one of those problems. If you need repair work, start with our Chimney Repair overview, then call (833) 467-7685 to get a camera inspection scheduled. We’ll show you exactly what we find and give you options, not a scare-sell.
Chimney Cap Installation
Signs you need it
You hear birds in the chimney, find nesting material in the firebox, or you’ve had water stains on the ceiling near the fireplace.
What it costs in Murrieta Hot Springs
Chimney cap installation in Murrieta Hot Springs typically runs $300 to $700, including the cap and setting it in the existing flue tile or on the crown.
How we do it
We measure the exposed flue, install a spark-arresting cap sized to the flue, and secure it with mechanical fasteners sealed against the crown.
Chimney Cap Replacement
Signs you need it
The existing cap is rusted through, missing sections of mesh, or has blown off entirely during a Santa Ana wind event.
What it costs in Murrieta Hot Springs
Replacing a damaged cap generally runs $350 to $750 in Murrieta Hot Springs, depending on the flue size and whether the old cap’s fasteners need repair.
How we do it
We remove the old cap, inspect the flue tile and crown underneath, install a new Famco or Copperfield cap, and seal every penetration point.
Chimney Liner Installation
Signs you need it
A camera inspection shows cracked clay tiles, gaps at the mortar joints, or flue gases bleeding into the chimney chase.
What it costs in Murrieta Hot Springs
Chimney liner installation in Murrieta Hot Springs typically costs $2,500 to $5,500, with DuraFlex stainless steel the standard material we specify.
How we do it
We size the liner to the connected appliance, run camera verification on the flue path, install a DuraFlex flexible liner where offsets make rigid liners impossible, and insulate the annular space as required.
Chimney Flashing Repair
Signs you need it
You see water stains on the ceiling near the chimney, peeling paint around the roofline, or rusted flashing at the roof penetration.
What it costs in Murrieta Hot Springs
Flashing repair in Murrieta Hot Springs generally runs $400 to $1,200, depending on how much of the roof-side water barrier needs replacing.
How we do it
We strip the failed flashing, replace it with a two-level system that moves water away from the roofline, and re-seal the entire penetration.
Chimney Crown Repair
Signs you need it
The crown has visible cracks, spalling concrete, or standing water pooling on top of the chimney.
What it costs in Murrieta Hot Springs
Crown repair in Murrieta Hot Springs typically costs $600 to $1,500, and a full crown replacement runs higher when the original was poured too thin.
How we do it
We rebuild or resurface the crown with a properly overhanging form, add expansion control at the flue tile, and seal it against the dry-heat cracking that’s common here.
What Chimney Repair Costs in Murrieta Hot Springs
| Item | Typical range in Murrieta Hot Springs |
|---|---|
| Chimney cap installation | $300 – $700 |
| Chimney cap replacement | $350 – $750 |
| Chimney flashing repair | $400 – $1,200 |
| Chimney crown repair | $600 – $1,500 |
| Chimney liner installation (DuraFlex) | $2,500 – $5,500 |
Do I always need a new liner if a camera shows cracked tiles?
No. In many Murrieta Hot Springs homes, HeatShield ceramic resurfacing can restore a damaged flue without a full tear-out liner replacement. We’ll show you the camera footage and tell you plainly which option applies to your chimney. Call (833) 467-7685 for a camera inspection and a straight answer.
What actually happens if I put off a flashing or crown repair?
Water keeps getting into the chimney structure and the framing around it. In Murrieta Hot Springs’s dry-and-windy pattern, the damage is slow until it isn’t. One heavy rain after years of neglect can leave you with drywall repair and mold mitigation on top of the chimney repair. Call (833) 467-7685 for an inspection before the next storm season.
Brands We Service in Murrieta Hot Springs
We work with a curated set of professional-grade brands: DuraFlex, HeatShield, and Famco. Parts are stocked for common sizes and the supply chain runs through Copperfield and Olympia Chimney, so turnaround on caps, dampers, and liner components in Murrieta Hot Springs is measured in days, not weeks. See our brands for the full list and why we specify these names.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Murrieta Hot Springs, CA
| Service | Typical range in Murrieta Hot Springs |
|---|---|
| Chimney sweep (visual + brush) | $180 – $340 |
| Chimney sweep with camera inspection | $250 – $500 |
| Dryer vent cleaning | $150 – $300 |
| Chimney cap installation | $300 – $700 |
| Chimney cap replacement | $350 – $750 |
| Chimney flashing repair | $400 – $1,200 |
| Chimney crown repair | $600 – $1,500 |
| Chimney liner installation (DuraFlex) | $2,500 – $5,500 |
What pushes pricing up in Murrieta Hot Springs is access. Two-story roofs, steep pitch, and gated communities with scheduled entry all add time. Santa Ana debris can also mean a flue is packed tighter than expected once we get eyes on it. What doesn’t push price up is surprise add-ons. We agree on a flat price before we start, and we document what we found with camera evidence so you never have to take a repair recommendation on faith.
Neighborhoods We Serve in Murrieta Hot Springs
We cover the full 92563 ZIP and the surrounding Murrieta Hot Springs communities. Most neighborhoods here are tract builds from the 1980s through the early 2000s, with masonry fireplaces and a mix of prefab inserts. Scheduling across the area is typically within a few days, and we’ll give you a firm arrival window when you book.
- Murrieta Hot Springs Road corridor
- Copper Canyon
- Greer Ranch
- Bella Vista
- Winchester Hills
Service Area – Cities Near Murrieta Hot Springs
Our crews work across the Murrieta, Temecula, Wildomar, and Quail Valley area. If you’re in Murrieta, CA, Temecula, CA, Wildomar, CA, or Quail Valley, CA, the same team that covers Murrieta Hot Springs can handle your chimney or dryer vent work. Call (833) 467-7685 and we’ll get you on the schedule.
Serving Murrieta Hot Springs, CA - Our Local Coverage Area
We’re based in the Murrieta Hot Springs area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Murrieta Hot Springs
We schedule Murrieta Hot Springs jobs within a few business days. If you’re dealing with an active leak or a visible chimney problem before a Santa Ana wind event, call (833) 467-7685 and we’ll tell you the soonest slot we have. We don’t promise same-day service because we’d rather give you a firm window we actually keep.
It depends on the community. Some Murrieta Hot Springs HOAs require approval for visible changes like a new chimney cap or crown color. We can tell you what’s visible from the street and whether it’s likely to trigger a review, and we’ll work around whatever approval timeline your HOA requires.
Debris and animal entry into rarely-used flues, and cracked crowns from the dry-heat cycle. Neither one fixes itself. The good news is both are straightforward repairs once we’ve put a camera down the flue. Call (833) 467-7685 and we’ll show you exactly what’s in yours.
For chimney repair, sweeping, or dryer vent cleaning in Murrieta Hot Springs, call Ontario Chimney at (833) 467-7685. We’ll give you a free estimate, show you the evidence, and tell you plainly what needs doing and what can wait.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you. The visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Murrieta Hot Springs Customers Say
"Level two inspection before we bought the house. The report was detailed enough to use as a negotiating point and he explained every photo in it."
- Sarah Sullivan"Good work. The written inspection report took about a week to arrive after I asked for it, which was slower than I expected."
- Adriana Morales"Cap keeps the birds out now, which after two springs of scratching noises is worth every penny."
- Tara Novak